Panasonic TOUGHBOOK CF-48 - Manual (Page 15)

Select your operating system
Select “Windows NT Workstation Version 4.00“ and press r Enter 0 ■
tWindowsiNT#
Logon
Press
CCtrD
+
(AH)
+
CDiD.
iWind^NT*
Input your password
Wait for 10 seconds after confirming that the HDD access has been completed, input the
user name and password, then select [OK], Until the correct user name and password are
entered, the computer will not operate.
iWindowsiNTp
If [Cancel] is selected, the computer will return to the initial [Begin Logon] display.
Select your application
You are able to start working on your computer.
T note >
The power saving function is factory set, so if there is no input from a key, the touch pad or
an external mouse (when one is connected) for a certain interval of time, the power to the
LCD and hard disk may be turned off. The LCD will resume operation when the touch pad
or an external mouse (when one is connected) is used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when an
application software is being installed. In this case, because it is conceivable that a selec­
tion dialog box will be shown, do not press ( Space ) or C EnteTl to attempt to resume
from this condition as doing so may trigger a selection, but instead, press a key unrelated to
the direct triggering of a selection, like ( Ctrl ].
IWi ndowsl98|liW i ndowsi2000l
In addition, when the computer is left alone, it automatically enters the standby* mode (Q*
“Standby/Hibemation Functions”). The computer will resume by pressing the
power switch.
: standby or hibernation
15