Panasonic TOUGHBOOK CF-48 - Manual (Page 12)

First-time Operation
Enter your computer name and administrator password and select [Next].
-------------------------------------------------
Remember this password! If the password is forgotten, Windows 2000 cannot be
operated.
V_______________________________________________________________________________________________________________________
@ Input the correct date, time and time zone and select [Next].
You can also complete these settings at a later time.
Q) At the [Networking Settings], select [Typical settings], then select [Next],
(8) At the [Workgroup or Computer Domain], select [No, this computer is not on a net­
work, or is on a network without a domain], then select [Next].
The computer will restart.
( 9) At the [Network Identification Wizard], select [Next].
0) At the [Users of This Computer], select [Users must enter a user name and password to
use this computer], then select [Next].
^ Select [Finish].
@ Enter your administrator password and select [OK].
note )-
At the [Getting started with Windows 2000]:
• Select [Exit] to close.
• When selecting [Discover Windows], the computer may ask you to install the Win­
dows 2000 CD. In such cases, close the windows, and then specify
[c:\winnt\cdimage\discover], then select [OK].
tWifTdowsiNTi
(?) The License Agreement will be displayed. After reading the agreement, select [I ac­
cept this Agreement].
note )-
J
If [I don’t accept this Agreement] is selected, the Windows setup will be aborted
Select [Next].
Input your name and organization, then select [Next], ([t is possible to omit the orga­
nization item.)
( 4) Input your computer name and select [Next],
( 5) Input an Administrator password and select [Next].
(^m>
r
Remember this password! If the password is forgotten, Windows NT cannot be
operated.
— - — *-
Select [Finish], Windows will restart.
( 7) Following the display, pressC Ctril + C AIt)+C Pel ). Input the password set in step
(Dand select [OK], then select [Close] at the [Welcome] display.
• As the computer starts up, it will be necessary to input the password set in step(^.
Set the correct settings for all items in [Control Panel]-[Regional Settings] and [Date/
Time] etc.
12