Panasonic WV-CB700A - Manual (Page 6)

117. Remote Control Box (RGB) Operation Switch
(RGB)
When connecting the Remote Control Box to the
camera without using the Remote Control Unit, set
this switch to ON position. When the RGB is
installed in the RGB this switch is inoperative.
118. Remote Control Box (RGB) Indicator
(ON/OFF)
This indicator iights while control data is
communicated between the camera and Remote
Control Unit (RCU) or Remote Control Box (RCB).
119. High Gain Selection Switch
(0 dB/+9dB/+18dB)
Normally set this switch to the 0 dB position.
Positions +9 dB and +18 dB increase the video
output amplitude for dark scenes and are equivalent
to opening the lens iris 1.5 or 3 F-steps, respectively.
120. 6dB Gain Selection Switch
(+6dB/OFF/-6dB)
Normally set this switch to OFF position. By
the combination of this switch with the High Gain
Selection Switch (119), fine adjustment of the gain
level is available.
121. Color Bar/Camera Selection Switch
(BAR/CAM)
In a system configuration, this switch is used for
signal selection between camera mode and color
bar mode.
BAR:
A' color bar signal is provided from the Video
Output Connector on the Remote Control Box
(RCB).
CAM:
The actual picture, as picked up through the
lens, is displayed.
122. Detail Level Selection Switch
(DTL, LEVEL-HIGH/LOW/OFF)
The detail/aperture level can be selected by this
switch in three steps. Set this switch to the
desired position while observing the sharpness of
the picture.
123. Red and Blue Gain Controls (R GAIN/B GAIN)
These controls are used to manually adjust the
white balance.
These controls only work when the White/Black
Balance Selection Switch (126) is set to the MANU
position.
- 4 -