Panasonic WV-BP120 - Manual (Page 9)

CONNECTIONS
Power Source
■ WV-BP120
Connect the AC Power Cord to a electrical outlet of
120V AC 60 Hz.
■ WV-BP124
1, A power supply of 24V AC 60 Hz is required.
2. Connect the power cable to the 24V AC In
Terminal on the rear panel of the camera.
Recommended wire gauge sizes for 24V AC line.
Copper wire
size (AWG) #24
(0.22mm')
#22
{0.33mm')
#20
(0.52mm')
#18
(0.83mm')
Length
of Cable
(Approx.)
(m) 95 150 255 425
(ft) 314 495 842 1403
Caution;
To prevent fire or shock hazard, the UL listed
wire VW-1, style 1007 should be used for the
cable for AC 24V Input Terminal.
Video Cable
1. It is recommended to use a video monitor whose
resolution is at least equal to the camera’s.
2. Terminate the camera output with 75ii resistor at
the furthest end of its cable run.
• It is recomm.ended to use 75Q coaxial cable.
• Always set the last monitor’s termination switch to
75il, and set the termination switches of intermedi­
ate monitors to high impedance (Hi-Z) position.
Monitor Monitor
The maximum extensible coaxial cable length
between the camera and the monitor is shown in
the table 1. Since cable quality varies among man­
ufactures, verify video quality before final installa­
tion if maximum lengths are to be used.
-7-