Panasonic WV-BP120 - Manual (Page 16)

(5) Both the connector cover and connector should
be positioned to interlock.
Note:
Cut off the rib on the connector, when the iris
control cable is too thick and the connector
cover and connector can not be interlocked.
3. Mounting the Lens
When you use the lens other than listed on pages 9,
10, 11 and 12, lens mount should be C-mount or spe­
cial C-mount (CS-mount r-32UN) and lens weight
should be less than 450g (0.99 lbs,). If not, both the
lens and camera should be secured.
The protrusion of the rear of the lens should be as
shown below.
C-mount: Less than ) 1.5 mm (7/i6")
CS-mount: Less than 7,2 mm (1/4")
Caution:
Always set the Flange-back adjusting ring to fully
clockwise (C-mount side) by loosing screws on the
ring before mounting the lens, otherwise the inner
glass and CCD image sensor could be damaged
by the lens.
(1) Mount the lens by turning it clockwise onto the
lens mount of the camera.
(2) Connect the lens cable to the Auto Iris Lens
Connector on the camera when an auto iris lens is
used.
(3) Set the Lens Selection Switch to the proper posi­
tion as follows.
-14-