Focus or flange-back adjustment – Panasonic WV-BP120 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DC:
The mounted lens, is one of the lenses listed
on pages 9, 10 and 11 or one that requires
the DC control signal for auto iris control.
VIDEO:
The mounted lens requires video signal for
auto iris control.
Note;
Refer to item on page 5 for the lens selectien
switch.
FOCUS OR FLANGE-BACK
ADJUSTMENT
The following adjustment should be made by qualified
service personnel or system installers.
1. Loosen screws on the flange-back adjusting ring.
Focus adjust for
C-mount lens
2. Turn the flange-back adjusting ring to the desired
position.
Caution: Do not turn this ring too much to counter
clockwise as this could damage the inner
glass and CCD image sensor.
3. Tighten the screws on the flange-back adjusting
ring.
Note: Do not apply the excessive torque (0.5
kg.cm, recommended) to the screws on the
flange-back adjusting ring.)
-15-