Panasonic CF-VEB341 - Manual (Page 7)

open the cover of the expansion bus connector of
the computer.
While holding the latch to the right side, slide the
lever all the way back. (UNDOCK POSITION)
(i
i)-
(FAUililON
Do not slide the lever without holding the latch to
the right side.
After confirming that the expansion bus connector
of the port replicator is positioned so that the com­
puter can be docked, insert the front comers of the
computer and then press down lightly on the rear
corners onto the port replicator guide pins.
8
Confirm that the lever has moved all the way to the
front. (DOCK POSITION)
r
Insert the left and right hooks
into the computer’s locking
holes.
Lever
# Do not attempt to make connections if there is any object between the computer and the port
replicator. Doing so could damage the computer and the port replicator,
# Do not attempt to move the port replicator when it is connected to the computer.
# If the computer malfunctions while the port replicator is attached, refer first to the "Trouble­
shooting" section of the computer’s "Operating Instructions". If you still are unable to solve the
problem, power off the computer, disconnect the port replicator, connect the AC adapter to the
computer, and check to see if the computer operates normally. If the computer operates normally
when the port replicator is not attached, the port replicator may be malfunctioning. Please con­
tact Panasonic Technical Support,