Overview, Installation hardware, Installation guide – Panasonic CQRX65EU User Manual
Page 15: Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Guide
A
WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers in attempting to install
this product.
Any attempt to install this product in a motor vehicle by anyone
other than qualified installer could cause damage to the electrical
system and could result in serious personal injury or death.
□ Overview
This equipment should be installed by a profession
al. However, if you plan to install this unit yourself,
your first step is to decide where to install it. The in
structions in these pages will guide you through the
remaining steps: {Please refer to “WARNING” state
ment above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
• Check the operation of the unit
If you do encounter problems, please consult your
nearest professional installer.
CAUTION: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not at
tempt to use it in any other system. Doing so could
cause serious damage.
Before you begin installation, look for the following
items included in the packing with your unit.
• Warranty Card....... Fill this out promptly
• MSC Servicenter Directory........ Keep for future
reference in case the unit needs servicing
• Installation Hardware ........ Needed for in-dash
installation
□ Installation Hardware
No.
Item
Diagram
Qty
©
Mounting Collar
1
Plain Washer {5 mmif))
2
Spring Washer (5 mm({))
2
©
Hex. Nut (5 mm(f>)
2
Rear Support Strap
1
Hex. Bolt
(5 mm(|)
X
25 mm)
1
©
Toothed Lock Washer
(5 mm(f>)
%
1
Mounting Bolt (5 mmc|))
1
®
Power Connector
1
Removable Face Plate
Case
1
CQ-RX65EU
15