Dynon Avionics FlightDEK-D180 Installation Guide User Manual
Flightdek-d180
Table of contents
Document Outline
- 1. INTRODUCTION
- 2. WIRING OVERVIEW
- 3. TRANSDUCER INSTALLATION
- Tools and Equipment Required
- Exhaust Gas Temperature (EGT) Probes
- Cylinder Head Temperature (CHT) Probes
- Tachometer
- Manifold Pressure Sensor
- Oil Pressure Sensor
- Oil Temperature Sensor
- Fuel Pressure Sensor
- Fuel Flow Sensor
- Fuel Level Sensor
- Ammeter Shunt
- General Purpose Inputs
- Contacts
- General Purpose Thermocouple
- 4. INSTRUMENT INSTALLATION
- Selecting a Remote Compass Module Location
- EDC-D10A Communication Cable
- Power Inputs
- Serial Communication Cables
- SL30 and/or GPS connection
- Altitude Encoder Wiring
- External EMS Warning Light
- Audio Alert Outputs
- Dynon Smart Avionics Bus (DSAB) Wiring
- Panel Location and Mounting
- Connecting Static & Pitot Lines
- 5. EFIS CALIBRATION AND CONFIGURATION
- 6. EMS CONFIGURATION
- Full-Page Setup Menu Overview
- Alarm and Color Threshold Configuration
- Global Parameters Setup
- Engine Type Configuration
- Fuel Level Calibration
- Trim Calibration
- Flaps Calibration
- Tachometer
- Manifold Pressure
- Oil Pressure
- Oil Temperature
- Exhaust Gas Temperature (EGT)
- Cylinder Head Temperature (CHT)
- Fuel Level
- Fuel Pressure
- Fuel Flow
- Voltage
- Current
- General Purpose Inputs
- Contacts
- General Purpose Thermocouple
- 7. DSAB CONFIGURATION
- 8. AUTOPILOT INSTALLATION AND CONFIGURATION
- Additional Information and Updates
- DSAB Firmware Compatibility
- Compass Calibration Critical For Certain AP Modes
- Autopilot System Electrical Installation
- Servo Mechanical Installation
- AP74 Mechanical Installation
- Firmware Upgrades Required For AP Functionality
- AP Servo Configuration
- CONFIGURATION OVERVIEW
- STEP 1 - CONFIGURE DSAB
- STEP 2 - SERVO CALIBRATION AND SERVO TEST
- STEP 3 - ROLL SERVO INITIAL SETUP
- STEP 4 – PITCH SERVO INITIAL SETUP
- STEP 5 – DISENGAGE/CWS BUTTON CONFIGURATION
- STEP 6 - AUDIO ALERTS CONFIGURATION
- STEP 7 – PREPARE FOR FLIGHT TEST ON CLEAR, VFR DAY
- STEP 8 – ROLL SERVO FLIGHT TUNING
- STEP 9 – PITCH SERVO FLIGHT TUNING
- STEP 10 – VERIFY OVERALL AP PERFORMANCE
- AP74 Configuration
- 9. APPENDIX
- Appendix A: Ongoing Maintenance and Troubleshooting
- Appendix B: Dynon EFIS OAT Probe Installation and Usage
- Appendix C: HS34 Installation and Configuration
- Appendix D: Dynon AOA/Pitot Installation and Calibration
- Appendix E: Encoder Serial-to-Gray Code Converter Installation
- Appendix F: Capacitance-to-Voltage Converter Installation
- Appendix G: Replacing the FlightDEK-D180 battery pack
- Appendix H: Weights
- Appendix I: FlightDEK-D180 Specifications