Dynon Avionics FlightDEK-D180 Installation Guide - Manual (Page 43)

Instrument Installation
EFIS SERIAL HARNESS
On the EFIS 25-pin wiring harness
available from Dynon, there are three
wires bundled together, terminating in a
standard DB9-pin female connector. This
cable is 6’ long and pre-assembled for
connection to a PC-based laptop. Route
this cable to a convenient location that can
be accessed whenever you need to update
your product’s firmware or checklists.
If you did not purchase a harness from
Dynon, obtain a 9-pin D-sub connector and make the three connections shown in the table.
To verify proper communication between the FlightDEK-D180 and the PC, use the Dynon
Avionics Product Support Program’s “Detect Firmware Version” function. Download the latest
version of the Support Program from the Dynon Web Site at
downloads.dynonavionics.com .
EMS SERIAL HARNESS
On the EMS 37-pin wiring harness available
from Dynon, there are three wires bundled
together, colored orange, yellow, and black, and
terminating in a standard D-sub 9-pin female
connector. If you did not purchase a harness
from Dynon, obtain a 9-pin D-sub connector
and make the three connections shown in the
table.
EFIS
DB25
Pin#
DB9
Pin#
Wire
Color
RS-232 Function
9 5 Black Signal ground
10 2 Orange FlightDEK-D180
transmit / PC receive
22 3 Yellow FlightDEK-D180
receive / PC transmit
EMS
DB37
Pin#
DB9
Pin#
Color Function
11 2 Orange
EMS Tx /
device Rx
12 3 Yellow
EMS Rx /
device Rx
30 5 Black RS232 Ground
FlightDEK-D180 Installation Guide 4-5