Dynon Avionics EMS-D120 Installation Guide - Manual (Page 49)

EMS Configuration
sensor, you will be presented with the values AuxSF and AuxOff. You must enter these values
according to the ones printed on your manifold pressure sensor, provided by GRT.
Oil Pressure
Select the alarm mode and the analog bar thresholds
as described in Alarm and Color Threshold
Configuration on page 5-2. If the oil pressure
transducer has been installed, set the DISPLAY
parameter to ON, otherwise, set it to OFF. Change
the SENSOR TYPE to the correct number using the
sensor type table.
Sensor
Type
Oil Pressure Sensor
1
Dynon P/N 100411-002 or
Rotax 912 pre-installed
(prior to mid-2008)
2 GRT HPS-01
3 Jabiru pre-installed
Rotax P/N 956413 (mid-
2008 and later
EMS-D120 Installation Guide 5-9
4
Oil Temperature
Select the alarm mode and the analog bar
thresholds as described in Alarm and Color
Threshold Configuration on page 5-2. If the
oil temperature sensor has been installed, set
the DISPLAY parameter to ON, otherwise,
set it to OFF. Change the SENSOR TYPE to
the correct number using the sensor type
table.
Sensor
Type
Oil Temp Sensor
1 Dynon P/N 100409-001
2 Dynon P/N 100409-000
3 GRT FT-LC-01
4 Rotax pre-installed
5 Jabiru pre-installed
6 Chevrolet LS7 pre-installed