4 configuration mode, 1 accessing the configuration mode, Chapter 4 configuration mode – Dillon Quick Balance Tension Meter User Manual
Page 18: Accessing the configuration mode, Configuration mode

18
Quick Balance User Instructions
4 Configuration Mode
4.1 Accessing the Configuration Mode
You need to access the Configuration mode to perform certain tasks. Access to some
of these tasks may be restricted by a supervisor password.
To access Configuration mode:
1.
From normal operating mode, press the Right Arrow softkey…
A new softkey set, shown below, appears:
2.
Press the Config softkey…
The following is displayed:
3.
Use the Num and Adv keys to enter the Config password. Default is 0. After
the number is displayed, press the Enter key…
The following is displayed:
The Num keys increment and decrement the displayed numbers. The Adv key
moves the cursor to the next digit position.
Default Configuration password is 0. If a new password is lost or forgotten, contact
your Dillon distributor.