CANOGA PERKINS 9160 10 Gigabit Ethernet Network Interface Device - Manual (Page 41)

Test a Connection With PING
When you set up a new connection or need to troubleshoot an existing connection to another device,
you can send a PING to the specific IP address for that device. Use the PING Generation screen to
test the connection. To set up and send a PING, follow these steps:
1. From the Diagnostics menu, type 2 , "PING Generation," and press .
2. At the PING menu prompt, set the PING parameters, and press .
"PING response received..." indicates a good connection;
"TIMEOUT: Unable to reach [IP address]..." indicates a faulty connection.
3. To stop the PING , press .
9160 10 Gigabit Ethernet Network Interface Device 4-5/(4-6 Blank)