CANOGA PERKINS 1500 Domain Management Module User Manual
Page 28

EdgeAccess Universal Chassis System
3-16
Model 1500 Domain Management Module
2. To add a destination, type
1
and press
3
and
press
values, or press
• IP Address for the destination
• Trap Notification Port for the destination; Range is 1 to 65535; typically set to 162
• Notification Type sets the security level for the destination, from V1-Trap through
V3-Inform
V1-Trap:
Unacknowledged message with SNMPv1 protocol
V2c-Trap:
Unacknowledged message with SNMPv2c protocol
V2c-Inform: Acknowledged
message with SNMPv2c protocol
V3-Trap:
Unacknowledged message with SNMPv3 authentication and optional encryption
V3-Inform:
Acknowledged message with SNMPv3 authentication and optional encryption
3. To finish setting up V1-Trap, V2c-Trap, or V2c-Inform notification, type the community
name, up to 10 characters, and press
4. To finish setting up SNMPv3-Trap notification, press
for these parameters:
• Security Name: The name of the user account at the DMM.
• Security Level: Can be "No Auth/No Priv" means no user authentication or encryption
for the message; "Auth/No Priv" means authentication by user name, but no encryption
for the message; "Auth/Priv" means authentication by user name and encryption for the
message.
5. To finish setting up SNMPv3-Inform notification, either type a value and press
press
• Security Name: Enter the name of the user account at the destination, up to 10 characters
• Engine ID: Enter the SNMP Engine ID at the destination; view it at the destination
configuration; 64 Hex characters.
• Authentication Protocol: Set how to authenticate the notification; can be MD5, SHA, or
None.
• Authentication Password: Enter the password that generates the authentication key for
the message if the authentication protocol is MD5 or SHA; 8 to 15 characters.
• Authentication Key: Shows the key that authenticates the notification for MD5 or SHA
Authentication Protocol; this is generated automatically for the Authentication Password,
but can be changed if the destination uses a different Authentication Key generation
algorithm; 16 Hex characters for MD5 protocol or 20 Hex characters for SHA protocol.
• Privacy Protocol: Set the protocol for encrypting the notification; can be DES
(authentication Protocol must be MD5 or SHA) or None
• Privacy Password: If the privacy protocol is DES, enter the password that generates the
encryption key for the message; 8 to 15 characters
• Privacy Key: Shows the key that encrypts the message for DES Privacy Protocol; this
is generated automatically for the Privacy Password, but can be changed if the destination
uses a different Privacy Key generation algorithm; 16 Hex characters