C.R.Plastic Products T51 - Manual (Page 3)

Proudly Made In CANADA
STEP 3: ASSEMBLING THE FRAME TO THE TOP
Figure 1
A) BEGIN BY POSITIONING THE TABLE TOP COMPONENTS AS SHOWN ( 1,2&3 in figure 1)
B) LIFT THE COMPLETED FRAME ASSEMBLY (STEP 2) INTO POSITION OVER THE TABLE TOP
AND INSERT THE 4 x 4 LEGS INTO THE FRAME OPENINGS. SECURE EACH OF THE FOUR LEGS
TO THE TABLE TOP USING A 3/8-16 x 6” SS CARRIAGE BOLT WITH NUT AND WASHER
POSITIONED IN COUNTERSUNK HOLE (figure 2). TIGHTEN BOLTS. (bolt locations- item 4 in figure 1)
Figure 2
C) COMPLETE TOP ASSEMBLY BY SECURING CENTER BOARD TO FRAME USING 8 - #8 x 1 ½”
SCREWS. ENSURE BOARD IS CENTERED IN OPENING BEFORE PROCEDING THEN INSTALL
SCREWS.( screw positions – item 5 in figure 1)