Beckett CF1000 - Manual (Page 4)

4
Frozen Plumbing and Water
Damage Hazard
If the facility is unattended in severely cold weather,
burner primary control safety lockout, heating
system component failures, power outages or other
electrical system failures could result in frozen
plumbing and water damage in a matter of hours.
For protection, take preventive actions such as
having a security system installed that operates
during power outages, senses low temperature
and initiates an effective action. Consult with your
heating contractor or security agency.
Follow these instructions
exactly.
Failure to follow these instructions, misuse, or
incorrect adjustment of the burner could result
in asphyxiation, explosion or fi re.
Contact a professional, qualifi ed service agency for
the installation, adjustment and service of your oil
burning system. Thereafter, have your equipment
adjusted and inspected at least annually to ensure
reliable operation. This work requires technical
training, trade experience, licensing or certifi cation
in some states and the proper use of special
combustion
test instruments.
Never store or use gasoline or other fl ammable
liquids or vapors near this burner or appliance.
Never attempt to burn garbage or refuse in this
appliance.
Never attempt to light the burner by throwing burning
material into the appliance.
Never attempt to burn any fuel not specifi ed and
approved for use in this burner.
Never restrict the air inlet openings to the burner or
the combustion air ventilation openings in the room. y
y
y
y
y
Owner’s Responsibility:
Impaired Burner Performance
& Fire Hazard
Do NOT operate the burner beyond specifi cations
outlined in the table on this page.
For applications beyond these limits, consult Beckett
Technical Services at 1-800-645-2876.
NOTE: Some packaged appliances with burners
may be agency listed as a unit to operate beyond
these limits. Consult the appliance manufacturer’s
specifi cations and agency approvals for verifi cation. ○
○
Follow these instructions
exactly.
Failure to follow these instructions could result
in asphyxiation, explosion or fi re.
Please read all instructions before proceeding.
Follow all instructions completely.
This equipment must be installed, adjusted and
started by a qualifi ed service agency that is licensed
and experienced with all applicable codes and
ordinances and responsible for the installation and
commission of the equipment.
The installation must comply with all local codes and
ordinances having jurisdiction and the latest editions
of the NFPA 31 and CSA-B139 & B140 in Canada. y
y
y
Service Agency Responsibility:
Specifi cations
Fuels
U.S. #1 or #2 heating oil only (ASTM D396)
Canada #1 stove oil or #2 furnace oil only
DO NOT USE GASOLINE, CRANKCASE
OIL, OR ANY OIL CONTAINING
GASOLINE.
Firing Range 4.0 to 10.0 GPH
Motor
½ HP 3450 RPM
120/60 Hz standard
6.5 amps @ 120 VAC
Optional voltages:(60 Hz or 50 Hz)
• 240 VAC/1-PH
• 208/240/480 VAC/3-PH
Ignition Trans. Continuous Duty, 120V/12,000V
Housing Cast aluminum
Fuel Unit 100 - 300 PSIG
Oil Nozzle 45° - 70° solid
Shipping
Weight
75 lbs.
Dimensions See Figure 8.
Section: General Information