Kidde KN-COSM-IBA - Manual (Page 23)

Alarm Removal
IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER
TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR
REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the
alarm in the direction of the “OFF” arrow on the cover.
Battery Replacement
If any form of battery failure is detected the red LED light will
flash and the unit will “chirp” one time, followed by the warning
message “LOW BATTERY”. This cycle will occur once every
minute, and will continue for at least seven days. On battery
power, the "LOW BATTERY" voice occurs once every 15 minutes.
If the red LED light flashes along with a chirp every 30
seconds, and is not followed by the voice message “LOW
BATTERY” as described above, and if the green LED flashes
twice per second (AC power only) your unit has
malfunctioned. Call our toll free Product Support Line at
1-800-880-6788 for instructions on how to return the unit.
BATTERY INSTALLATION AND REMOVAL
To replace or install the batteries slide the battery door in the
direction indicated on the cover of the alarm. When installing
new batteries into the carrier, make sure that the polarity
matches the markings printed on the inside of the battery
compartment, press the battery reminder finger down into the
battery compartment and install the
battery (see Figure 6). Completely
slide the battery door to the
closed position. A missing or
improperly installed battery will
prevent the battery door from
closing and result in improper
alarm operation.
Battery Replacement
21
SLIDE OPEN INSERT
FIGURE 6
Battery
finger
2544-7201-01(KN-COSM-IBA)_V2.qxd:_ 2014.5.29 4:35 PM Page 23