beautypg.com

Operating instructions – Kidde KN-COSM-IB User Manual

Page 17

background image

• When mixing compatible models with battery backup with models

without battery backup, be advised that the models without battery

backup will not respond during an AC power failure.

• This unit is only approved to interconnect with other

Kidde/Nighthawk products. It is NOT approved to interconnect

with any other brand of detection product.

• This alarm is interconnect compatible with the following alarms

and accessories:

–Smoke alarms: 1235, 1275, 1276, 1285, i12020, i12020A,

i12040, i12040A, i12060, i12060A, i4618, i4618A,

KN-SMFM-I, RF-SM-ACDC, PE120, P12040, Pi2000, Pi2010,

KN-COSM-I, KN-COSM-IB,

Kidde/Firex: i4618, i4618A

– Heat alarm: HD135F

– CO alarms: KN-COB-IC, KN-COP-IC, KN-COPE-I

– Relay modules: SM120X, CO120X

– Strobe Light: SL177i, SLED177i

See User Guide for specific application information.

• For more information about compatible interconnect units and

their functionality in an interconnect system, visit our web site

at www.kidde.com.

Smoke HUSH Control Feature

The HUSH feature has the capability of temporarily desensitizing
the smoke alarm circuit for approximately 9 minutes. This feature
is to be used only when a known alarm condition, such as smoke
from cooking, activates the alarm. When the unit is in alarm,You
can put your Smoke/CO Alarm in HUSH mode by pushing the
test/reset button. If the smoke is not too dense, the alarm will
silence immediately, the unit will verbally announce “HUSH
MODE ACTIVATED”, and the green LED will flash every 2
seconds for approximately 9 minutes. This indicates that the
smoke alarm is in a temporarily desensitized condition. Your
Smoke/CO Alarm will automatically reset after approximately 9
minutes. When the unit returns to normal operation after being
in HUSH mode, it will verbally announce “HUSH MODE
CANCELLED”, and sound the alarm if smoke is still present. The
HUSH feature can be used repeatedly until the air has been
cleared of the condition causing the alarm. While the unit is in
HUSH mode, pushing the test/reset button on the alarm will also
end the HUSH period.

NOTE: DENSE SMOKE WILL OVERRIDE THE HUSH CONTROL
FEATURE AND SOUND A CONTINUOUS ALARM.

15

Operating Instructions

2544-7201-00(KN-COSM-IBA)_V4a.qxd:_ 2013.7.1 2:44 PM Pag

This manual is related to the following products: