Eng li s h – Clarion VMA7196 User Manual

Page 12

VMA5096/VMA7196

ng
li

Before starting

Disconnect the ground (-) terminal on the vehicle’s battery.

WARNING!

To prevent short circuits during installation,
be sure to disconnect the battery.

Precautions

• This unit is exclusively for vehicles with a negative ground, 12V power supply.
• Do not open the case. There are no user-serviceable parts inside. If you require

assistance, consult your Clarion dealer or an authorized Clarion service center.

• Use a soft, dry cloth to clean the screen. Never use a rough cloth, thinner, benzene,

alcohol, or other solvent. The screen surface is easy to scratch—do not rub it when
cleaning.

• Always use great care when attaching anything to a vehicle! Visually inspect all

sides of any potential screw location to ensure no damage will occur.

WARNING!

NEVER install this monitor where it is visible from the driver’s
seat, or where it could injure any vehicle occupant in case of
an accident. Ensure that your installation does not create risk
of head-strike injury, and that the monitor will remain se-
curely mounted in the case of an accident or sudden maneu-
ver.

Installing the monitor

These TFT LCD monitors are designed for custom installation. While a basic flush-
mount bezel is supplied, you may need parts that are not included (depending on your
installation). Clarion also offers optional mounting kits:

• The ZMT003 is a flexible gooseneck mount.
• The PQE023 positions the monitor on the back of a vehicle headrest.

Note

The Clarion HRM100 and HRM150 headrest mounting kits are not
compatible with this monitor.

VMA5096_VMA7196_OwnersManual_rev.pmd.p65

11/23/05, 2:53 PM

This manual is related to the following products:

VMA5096