Sangean U4 (V1) - Manual (Page 30)

29
If you wish to completely reset your radio to its initial state this
maybe performed by following this procedure. By performing a fac-
tory reset, all user entered settings will be erased.
. Press the Menu button to enter the setting.
2. Rotate the Tuning control until ‘FACTORY’ shows on the dis-
play. Press the Tuning control to enter the setting.
3. Rotate the Tuning control to choose ‘YES’ and press the Tuning
control to confirm the setting. A full reset will be performed. The
station list and presets will be erased. Alarms will be cancelled
and sleep timer settings will be set to their default values.
If you do not wish to carry out a system reset, select 'No' and then
press the Tuning control. The display will revert back to the previ-
ous display.
In case of malfunction due to electrostatic discharge, reset the
product using the above procedure. In some circumstances it may
be necessary to disconnect and then reconnect the mains power in
order to resume normal operation.
The software display cannot be altered and is just for your reference.
. Press the Menu button to enter the menu setting.
2. Rotate the Tuning control until ‘FM X KHZ’ or ‘AM X KHZ’ shows
on the display. Press the Tuning control to enter the setting.
3. Rotate the Tuning control to choose desired FM tuning step (50
kHz or 100 kHz) or AM tuning step (9 kHz or 10 kHz). Press the
Tuning control to confirm the setting.
Factory reset
Software version