Sangean U4 (V1) - Manual (Page 14)

3
Operating your radio – FM/AM auto-tune
. Straighten up the antenna.
2. Press the Power button to switch on your radio.
3. Press and release the Source button until the FM (1 or 2)/AM
band is selected.
4. Press and release the Tuning control to cause your radio
to search from low frequency to high frequency and to stop
automatically when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will
show the frequency of the signal found.
6. To find other stations press the Tuning control as before.
When the end of the waveband is reached, your radio will
recommence tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Power button.
Note:
If you find the reception is poor, try repositioning the antenna.
Manual tuning – FM/AM
. Straighten the antenna.’
2. Press the Power button to switch on your radio.
3. Press and release the Source button until the FM (1 or 2)/AM
band is selected.
4. Rotate the Tuning control to tune to a station. The frequency will
change in steps of 50kHz.
5. When the waveband end is reached the radio will recommence
tuning from the opposite waveband end.
6. Set the Volume to the desired setting.