Pigtronix Rototron - Manual (Page 7)

3. Getting Started
3.1 Basic Setup
1. Unpack your Rototron and place it on a flat, stable surface.
2. Make sure you have the 18-Volt DC (negative center) power
supply that came with your Pigtronix Rototron.
3. Plug the power cord into the DC Power jack on the back of
the Rototron and then plug the power adaptor into an electrical
socket. The Rototron is now powered up. To turn the device off,
unplug it from the wall or turn off the power going to the 18VDC
supply. We recommend that you do not leave your Rototron
powered up for long periods of time when it is not in use.
4. If your instrument has only one output plug it into the In 1 jack.
Otherwise, plug the left output into In 1 and the right output
into In 2.
5. Plug your Amplifier into the Out 1 jack. If you have a second
amp, plug it into the Out 2 jack.
6