Compaq Keyboard/Monitor/Mouse Switch Box - Manual (Page 11)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-2 Installation
Writer: Kristi Wishon Project: Installation Comments:
File Name:E-ch02.doc Last Saved On:9/6/96 3:18 PM
HYDR-003.EPS
Figure 2-1. Attaching slide rail brackets
Preparing the Rack-Mount
Brackets
Prepare the rack-mount brackets for cable management in the rack by
attaching the plastic cable ties. The cable ties snap into place, with the tie on
the outside of the bracket. See Figure 2-2. After the cable ties are in place,
install the rack-mount brackets in the rack by sliding the two back tabs in the
back mounting rail. Secure the rack-mount brackets in the front mounting rail
with two 6mm screws each, making sure to use only the top and bottom holes.
The middle will be used for attaching the front cover panel after the unit is
fully installed. Also install the cable rod in the back of the unit in the two
keyhole-shaped holes. Push the rod down to lock it in place.