OFNA Racing 91849 DigiPeak 3 - Manual (Page 2)

Charge Mode
1.MAIN MENU -> press the (ENTER) into charge mode.
2.Set the current rate before charging. Adjustable charge rates from 300mA-5000mA.
The default current is 2A, you can use the +(INCREASE) and -(DECREASE) button
to adjust the charge rate.
See the table below to select the charge rate for Ni-Cd & Ni-MH battery packs. We
recommend that you charge 1800mAh receiver packs at 1.8 amp. (1C).
It's normal situation if the current value of Ni-Cd & Ni-MH turn to zero after period
of charging.
An exhausted Li-Po battery pack can be fully recharged in approximately 2-3 hours
with charge rate at 1C.
To Re-peak the pack, simply press the S(START) button.
Press the (ENTER) button to show MAX. voltage.
The cooling fan will work when you press the S(START) button to start charging.
Discharge Mode
1.MAIN MENU -> press the (ENTER) and then the +(INCREASE) button into
discharge mode.
2.The discharge rate is 0.3A~2.0A (Adjustable).
It's necessary to set discharge bottom voltage of Ni-Cd & Ni-MH, single cell can't
lower than 0.8V,
6cells can't lower than 4.8V.
END DISCHARGE
1.To Re-Discharge the pack simply press the S(START) button.
2.Press the (ENTER) button to return MAIN MENU.
Cycle Charge Mode (Discharge Charge)
MAIN MENU -> press the (ENTER) and then the +(INCREASE) button
twice into charge after discharge mode, and then press the S(START) button
to start.
Before you get into this mode, you have to set the charge / discharge rate and the
discharge voltage.
A
A
A
B
B
C
B
C
D
E
F
G
H
Battery Capacity Charge Rate Charge Time
600mAH 0.6A 60 ~ 80 Min.
1300mAH 1A 78 ~ 94 Min.
2A 54 ~ 65 Min.
3300mAH 5A 40 ~ 48 Min.
2