50 assembly of the air filter, No.11, 51 assembly of the tires and wheels – OFNA Racing DM-1 Spec User Manual

Page 23: Assembly of the onto front knuckle and rear hub

ASSEMBLY OF THE ONTO FRONT KNUCKLE AND REAR HUB

Step 1

Step 2

Nylon Screw

Do Not
Over Tighten

Take off the doubleside
paper before assembly.

Side Plate

Doubleside
Tape

Nylon Nut

Cut Out

ASSEMBLY OF THE AIR FILTER

38400
Air Filter

Nylon Strap

*Notice the direction and make two lift and
right hand side tires are the same.
*Check the rotation direction before gluing.

NO.11

BAG

10179
Fuel Tube

Connect to
pressure nipple.

Connect to fuel tank
pressure nipple.

Connect to carburetor.

Connect to
fuel tank.

*Apply filter oil to the
foam before use.

ASSEMBLY OF THE TIRES AND WHEELS

86023
Wheel

86059
Inner Sponge
(WidE)

86052
Tire

86059
Inner Sponge
(Narrow)

*Notice the direction
of the tires.

INSTA

(Right Hand Side)

(Left Hand Side)

Contact
Adhesive

*Notice the direction of the tires. Make two
the same for the left and 2 for the right.
Check the rotation direction before gluing.

*Pull back the tire bead slightly and spot glue in four spots as
shown. When dry, glue the rest of the wheel between the spots.
Repeat the procedure on the other side of the wheel until fully
glued.