Pro-Link Lithofin FZ Stain-Stop 120024 - Manual (Page 3)

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin FZ Stain-Stop
3
Avoid inhalation of vapours.
Information about protection against explosions and fires:
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
Storage
Requirements to be met by storerooms and receptacles:
Store receptacles tightly closed at a cool and dry place with sufficient ventilation
Provide solvent resistant, sealed floor.
Prevent any seepage into the ground.
Information about storage in one common storage facility:
Store away from foodstuffs.
Store away from feed.
Further information about storage conditions: None.
Storage class 3A Flammable liquid
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
123-86-4 n-butyl acetate
PEL: 710 mg/m³, 150 ppm
REL: short-term value: 950 mg/m³, 200 ppm
long-term value: 710 mg/m³, 150 ppm
TLV: short-term value: 950 mg/m³, 200 ppm
long-term value: 713 mg/m³, 150 ppm
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Do not inhale dust / smoke / mist.
Do not eat or drink while working.
Use skin protection cream for skin protection.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer
exposure use respiratory protective device that is independent of circulating air.
Short term filter device:
Filter A
NIOSH/MSHA-approved respirator
Protection of hands:
Wear chemically resistant protective gloves (tested according to DIN EN 374)
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material