Pro-Link Baseboard Stripper FA003 EN User Manual
Pro-Link For Home
M A T E R I A L S A F E T Y D A T A S H E E T
MSDS
859
Page 1
MSDS
ITEM NUMBER: FA003
IDENTITY (As Used On Label and List): Baseboard Stripper
E M E R G E N C Y M E D I C A L Telephone# 1-800-228-5635 (24 Hrs)
Outside of the U.S.A. Call 651-632-9275
PRODUCT HAZARD RATINGS (NFPA): Health = 1, Fire = 2, Reactivity = 0, Protective Equipment = B
(Rating Legend: 4 = Extreme, 3 = Serious, 2 = Moderate, 1 = Slight, 0 = Minimal)
SECTION I
PRO-LINK
TELEPHONE NUMBER FOR INFORMATION: 1-800-74LINKS
DATE
PRINTED:
3/1/05
Canton, MA 02021
NAME OF PREPARER: Regulatory Compliance
SECTION II - HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
Chemical Names CAS# SARA Title III ACGIH OSHA % By Wt.
SEC 313 TLV/TWA PEL
2-Butoxyethanol
111-76-2
Yes
20 ppm*
25 ppm*
20-30
Tetrasodium EDTA
64-02-8
No
NA
NA
1-5
Organic phosphate ester 68412-53-3
Yes
1mg/m3
1mg/m3
1-5
Liquified petroleum gas mixture See below
No
--
--
10-20
Propan 74-98-6
--
1000
ppm
NE
--
n-Butane 106-97-8
--
600
ppm
NE
--
* Skin
Balance of ingredients are non-hazardous or below reportable levels.
SECTION III - PHYSICAL CHARACTERISTICS
Boiling Point: NA Vapor Pressure (psig): 115+/-5@130F Specific Gravity (H20=1): <1
Solubility/Water: Slight Vapor Density (AIR=1): >1 Evaporation Rate (Ether=1): <1
Appearance and Odor: Semi-stable, foaming spray, pine solvent odor.
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Aerosol Flammability: Product is not required to be labeled as flammable as described in 16 CFR 1500.3 and 1500.45.
Flashpoint: <0F (Propellant); 100F (Concentrate)
Flammable Limits - % Volume In Air (Propellant): LEL: 1.9 UEL: 9.5
Extinguishing Media: Carbon dioxide, foam and/or dry chemical may be used.
Special Fire Fighting Procedures: Containers should be cooled with water to prevent vapor pUse equipment or
shielding, as required, to protect personnel from bursting, rupturing or venting containers.
Unusual Fire and Explosion Hazards: At elevated temperatures (over 54C-130F) containers exposed to direct
flame or heat contact should be cooled with water to prevent weakening of container structure.
SECTION V - REACTIVITY DATA
Stability: Stable Hazardous Polymerization: NA
Incompatibility (Materials to Avoid): Strong oxidizing materials, reactive metals, heat and open flame.
Hazardous Decomposition Products: Carbon dioxide, carbon monoxide and additional toxic chemicals may be
formed in small amounts. Conditions to Avoid: Do not store above 54C-130F. Keep away from heat, direct
sunlight, open flames or sparks. Dropping of containers may cause bursting.