Wilbur Curtis CGC - Manual (Page 19)

19
Cleaning the Brew Cones
Clean the dispensing spout of the brew cone once a month or more often in locations
where the unit gets heavy use.
1. Look into the brew cone to locate the cap covering the spout tube. Remove this
cap by grasping the top portion and pulling it straight up.
2. Clean the inside orifice of the spout tube. For better cleaning, you can mix a
mild dish washing solution to use while cleaning. Insert a small brush through
the spout tube from the outside of the brew cone. Spin the brush a few times to
remove any coffee residue.
Look inside the brew cone and verify that the brush has gone completely
through the spout.
3. Clean the small opening on the side of the spout tube. Insert the brush into the
side opening and spin it a few times. Run the brush completely through the side
opening.
4. Rinse the brew cone with clear water. Observe the flow of water from the dis-
pensing spout to make sure you have a good flow. Cover the spout tube with the cap.
Rough-In Drawing