beautypg.com

General safety rules – Ryobi DP121 User Manual

Page 4

background image

4

GENERAL SAFETy RULES

DO NOT USE TOOL IF SWITCH DOES NOT TURN IT
ON AND OFF.
Have defective switches replaced by an
authorized service center.

ALWAyS TURN SWITCH OFF before disconnecting it to

avoid accidental starting.

NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal

sparking of the motor could ignite fumes.

INSPECT TOOL CORDS PERIODICALLy. If damaged,

have repaired by a qualified service technician at an
authorized service facility. The conductor with insulation
having an outer surface that is green with or without yellow
stripes is the equipment-grounding conductor. If repair
or replacement of the electric cord or plug is necessary,
do not connect the equipment-grounding conductor to a
live terminal. Repair or replace a damaged or worn cord
immediately. Stay constantly aware of cord location and
keep it well away from the rotating blade.



INSPECT EXTENSION CORDS PERIODICALLy and

replace if damaged.



GROUND ALL TOOLS. If tool is equipped with three-

prong plug, it should be plugged into a three-hole electri-

cal receptacle.

USE ONLy CORRECT ELECTRICAL DEVICES: 3-wire

extension cords that have 3-prong grounding plugs and

3-pole receptacles that accept the tool’s plug.



KEEP TOOL DRy, CLEAN, AND FREE FROM OIL AND

GREASE. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum-based products, or
any solvents to clean tool.



NEVER START A TOOL WHEN ANy ROTATING

COMPONENT IS IN CONTACT WITH THE WORK-
PIECE.



DO NOT OPERATE A TOOL WHILE UNDER THE

INFLUENCE OF DRUGS, ALCOHOL, OR ANy
MEDICATION.

WHEN SERVICING use only identical replacement parts.

Use of any other parts may create a hazard or cause
product damage.



USE ONLy RECOMMENDED ACCESSORIES listed in
this manual or addendums. Use of accessories that are
not listed may cause the risk of personal injury. Instruc-
tions for safe use of accessories are included with the
accessory.

IF THE POWER SUPPLy CORD IS DAMAGED, it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.