Ryobi DP121 - Manual (Page 21)

21
ADJUSTMENTS
WARNING:
Before performing any adjustment, make sure the tool is
unplugged from the power supply. Failure to heed this
warning could result in serious personal injury.
ADJUSTING TABLE HEIGHT
See Figure 22.

Hold the table with one hand and loosen the table lock
handle.
 Rotate the table adjustment handle clockwise to raise the
table.
 Rotate the table adjustment handle counterclockwise to
lower the table.
 Position the table to the desired height and retighten the
table lock handle.
ADJUSTING TABLE BEVEL
See Figure 23.
The drill press is equipped with a tilting table that allows
you to drill angled holes. The table can be tilted left or right,
from 0º to 45º.
To tilt the table:

Loosen the large hex bolt located underneath the table.
 Use the bevel scale to tilt the table to the desired angle.
 Retighten the hex bolt securely.
ADJUSTING THE DRILLING DEPTH
See Figure 24.
To adjust the drilling depth when you need to drill a number
of holes to exactly the same depth:

Loosen the lock knob and the spindle lock lever.
 Rotate depth gauge to the desired setting.
 Retighten the lock knob securely using the hex key, if
needed.
table
adjustment
handle
table lock
handle
hex bolt
beVel
scale
Fig. 22
Fig. 23
lock
knob
Fig. 24
dePth
GauGe