Assembly – Ryobi DP121 User Manual
Page 13
13
UNPACKING
This product requires assembly.
Carefully remove the tool and any accessories from the
box. Place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected the tool, identified all loose parts, and
satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the missing parts are replaced. Failure to heed
this warning could result in possible serious personal
injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
ASSEMBLy
Fig. 5
ATTACHING COLUMN ASSEMBLy TO BASE
See Figure 5.
Place the base on a flat surface. Align screw holes in the
column assembly with screw holes in the base.
Place a hex bolt in each hole and tighten using an adjust-
able wrench.
base
hex bolt
column
assembly