Ryobi DP121 - Manual (Page 14)

14
ASSEMBLy
INSTALLING TABLE AND TABLE SUPPORT
See Figures 6 - 8.
 Loosen the set screw in the column collar. Remove the
column collar and gear rack from the column and set
aside.
 Locate the worm gear and feed the D-shaft through the
hole in the table support.
 Feed the gear rack through the slot in the table support so
that the teeth are facing out and the longer smooth end
faces up. The worm gear should engage the gear rack.
 Using both hands, slide the entire table support and gear
rack onto the column until the bottom of the gear rack is
positioned in the base collar and against the column.
 Slide the column collar, bevel-side down, over the column
until the beveled side engages the beveled end of the
gear rack. Tighten the set screw in the collar using the
hex key. Do not overtighten.
NOTE: You should be able to move the table support
from side to side.
 Install table adjustment handle over the end of the
D-shaft so that the flat side of the shaft aligns with the
set screw. Using the hex key, tighten the set screw on
the table adjustment handle.
 Locate the table lock handle. Insert it into the threaded
hole at the rear of the table support and tighten by
hand.
 Remove protective covering from the table and discard.
Place the table in the table support and tighten the table
lock handle by hand.
NOTE: If the table won’t fit into the table support
easily, pry open the table support with a flat blade screw-
driver.
Fig. 7
threaded
hole
table
lock
handle
Fig. 8
worm
Gear
Fig. 6
d-shaft
slot
Gear
rack
table
suPPort
column
collar
set
screw
base
collar
set
screw
table
adjustment
handle
table
suPPort
table
suPPort
table
table
lock
handle