Petsafe Innotek FieldPro Remote Trainer - Manual (Page 14)

FieldPro Owner’s Manual 14
Power Up
To turn the Receiver ON or OFF, hold
the Receiver within one inch of the
Transmitter antenna as shown in the
Quick Start Guide. Be careful, do not
touch the metal contacts that touch your
dog’s skin. Press the Tone/
ON/OFF button. When turning
ON, the Receiver’s light will show battery
charge level (green, amber, or red).
This ON/OFF command only works
when the Transmitter and Receiver are
close together; it will not work at a
distance. Never turn the system on or off
while your dog is wearing the collar
Auto Shut Off
When the Receiver is on and doesn’t
receive a command from the Transmitter
for 6 straight hours, it will automatically
shut itself off. This INNOTEK feature
saves Receiver battery power for field
work, rather than using it up being idle.
Follow Power Up instructions (bottom of
previous column) to turn on your
Receiver again.
ReadyTest ™ Self-Test
When you remove the Receiver from the
charging cradle, it automatically goes
into ReadyTest
™ (a diagnostic self-test)
for 5 seconds. The Receiver’s internal
diagnostics check the battery charge
level (the Receiver LED light indicates
battery charge level) and checks that all
circuits are working. Do not touch the
metal contacts during this test. Touching
the contacts after removing the Receiver
from the charging cradle may cause
ReadyTest
™ to fail. ReadyTest ™ gives you
confidence that your Receiver is working
properly, and is ready to go. After the
Receiver passes ReadyTest
™ , it shuts
itself off. If ReadyTest ™ fails, the unit
makes a 20-second tone, the LED
glows solid red for 20-seconds, and
then shuts off. A Receiver that fails
ReadyTest
™ will not respond to the
Transmitter’s commands. To retest the
Receiver, place the Receiver back on
the charger for 5 seconds, then remove
it. D
Do o n no ott tto ou uc ch h tth he e m me etta all c co on ntta ac ctts s.. If the
unit repeatedly continues to fail, call us
at 1
1--8 80 00 0--8 82 26 6--5 55 52 27 7.
Receiver Status Indicators
Status Light Alarm Condition
Pulsating Green
Duration of Tone
Button press Tone Only —
No Stimulation
Pulsating Red
Duration of
Stimulation
Button press
Stimulation
being delivered
Continuous
Green
No Tone
Over-stimulation
warning: Receiver
is locked out for
10 seconds
Blinking Green No Tone
Receiver battery
is at 60%
strength or better
Blinking Amber No Tone
Receiver battery
is 60 — 20%
strength
Blinking Red No Tone
Receiver battery is
less than 20% —
Recharge now
After removing receiver from charging cradle...
Continuous
Green, Amber,
or Red
No Tone
Battery indicator
— see above
Continuous Red
Tone for
20 seconds
Self-test failure;
Receiver is not
operational
While receiver is on charging cradle...
Continuous Red No Tone
Battery charge
in progress
Continuous
Green
No Tone
Battery charge
complete
No Light No Tone
Battery charge
failure