Petsafe Elite Big Dog Add-A-Dog® Extra Receiver Collar - Manual (Page 11)

www.petsafe.net 11
Step 2
Prepare the Receiver Collar
Charge the Receiver Collar
1. Lift the rubber cover protecting the Receiver Collar Charging Jack.
2. Connect the charger connector to the Receiver Collar Charging Jack.
3. Plug the charger into a standard wall outlet.
4. Charge the Receiver Collar until the Green Indicator Light comes on and is solid. Recharges
take only 3-4 hours.
5. When charging is completed, replace the rubber cover.
Little Dog Receiver Collar Big Dog Receiver Collar
Charger connector
placed in Receiver
Collar Charging Jack
Charger
connector
placed in
Receiver Collar
Charging Jack
To Turn the Receiver Collar On
1. Press and hold the On/Off button until the Green LED comes on and the Receiver Collar
beeps low to high.
2. Release the On/Off button. The Green LED will flash once every 5 seconds until the Receiver
Collar is turned off. The flashing light indicates the Receiver Collar is ready to receive a radio
signal from the Handheld Remote.
3. Once the Receiver Collar has been turned on, press the Tone (upper left button) of the Handheld
Remote. Upon pressing, the Receiver Collar should beep for as long as the Upper Left button
is pressed. If it does not, see “To Pair the Handheld Remote and the Receiver Collar”. Note: To
extend the life of the battery, turn the Receiver Collar off when it is not in use.
Little Dog Receiver Collar Big Dog Receiver Collar
On/Off
Button
(On bottom
of receiver)
On/Off
Button