The snmp traps screen, 1 trap table screen fields, Chapter 6 – Cabletron Systems ESXMIM User Manual
Page 45: Trap table screen fields -1, Chapter 6 the snmp traps screen, Esxmim/esxmim-f2 local management guide page 6-1, Trap destination
ESXMIM/ESXMIM-F2 Local Management Guide
Page 6-1
CHAPTER 6
THE SNMP TRAPS SCREEN
This chapter explains how to configure the SNMP Traps screen to allow
the ESXMIM to send traps to as many as eight remote management
workstations. SNMP traps are messages about network events and device
operational statistics. The following sections explain SNMP Trap screen
fields and instructions for configuring them. Figure 6-1 shows the SNMP
Traps screen.
Figure 6-1
The SNMP Traps Screen
6.1
TRAP TABLE SCREEN FIELDS
The following definitions explain each of the SNMP Traps screen fields:
Trap Destination
Use this field to enter the IP address of the management workstation
designated to receive SNMP traps from the ESXMIM.
SNMP TRAPS
Trap Community Name
Trap Destination
Enable Traps
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
public
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
SAVE
RETURN
10
public
public
public
public
public
public
public
Event Message Line
ESXMIM Local Management
Flash Image Version: XX.XX.XX