Cabletron Systems ESXMIM - Manual (Page 12)

Chapter 1: Introduction
Page 1-2 ESXMIM/ESXMIM-F2 Local Management Guide
Chapter 5, The SNMP Community Names Screen , explains how to
control access to the ESXMIM by assigning community names.
Chapter 6, The SNMP Traps Screen , explains how to configure the
ESXMIM to send SNMP trap messages to multiple network management
stations.
Chapter 7, The FLASH Download Screen , describes how to download a
new firmware image to the ESXMIM’s FLASH EEPROM.
Chapter 8, The Bridge Setup Screen , describes how to configure the
ESXMIM for bridge functions.
Chapter 9, The Module Specific Setup Screen , describes how to
configure the ESXMIM interface 1 connection method.
Chapter 10, The Component Status Screen , discusses how to view the
status of ESXMIM MIB components.
Chapter 11, The Interface Statistics Screen , discusses how to configure
the ESXMIM to gather statistics for each interface.
Chapter 12, The MIB Navigator Screen , describes how to access and
use the MIB Navigator screen. This chapter also includes examples for
MIB Navigator commands.
1.2 DOCUMENT CONVENTIONS
The following conventions are used throughout this document:
NOTE
Note symbol. Calls the reader’s attention to any item of
information that may be of special importance.
TIP
Tip symbol. Conveys helpful hints concerning procedures or
actions.
!
C AUT IO N
Caution symbol. Contains information essential to avoid
damage to the equipment.