Campbell Hausfeld SM4M - Manual (Page 13)

Section 1. SM4M/SM16M Storage Module Overview
1-7
For the CR7 and 21X without Instruction 96, the *4 Mode can be used to send
data to the storage module. The Output Enable code should be set to X1, Printer
Enabled ASCII.
The DSP4 outputs data to a storage module when the storage module function (or,
for older versions of software, the printer function) is enabled.
1.5.3 Manual Dump
The *8 Mode in the CR500/510, CR10/10X, CR23X or the *9 Mode in the 21X
and CR7 can be used to transfer data to the SM under keyboard control (See
Section 4).
1.5.4 Data Retrieval
The simplest method of retrieving data from the Storage Module is to use SMS
which is part of the PC208W support package. If you have a computer which
cannot run this software, the SM telecommunications commands can be used to
retrieve the data. Data retrieval (including interface devices) is discussed in
Section 5.