NextoDI NVS2501 - Manual (Page 25)

43
ADVANCED FUNCTIONS ADVANCED FUNCTIONS
44
3. Buzzer
149.0 GB
Preview
Select Back
HDD Management
Sector Recovery
Buzzer On
Sync
Language
Firmware Update
Index AutoGen. Off
149.0 GB
Preview
Select Back
HDD Management
Sector Recovery
Buzzer Off
Sync
Language
Firmware Update
Index AutoGen. Off
4. Firmware Update
Firmware Update
Select a File
in HDD
in Memory Card
v1.0
Select Back
149.0 GB
Preview
Select Back
HDD Management
Sector Recovery
Buzzer
On
Sync
Language
Firmware Update
Index AutoGen. Off
The Buzzer is on. Select “BUZZER “from the main
menu to turn the buzzer sound on/off with by
briefly pressing the control key. The factory
default setting is buzzer on.
The Buzzer is now off. If the control key is
briefly pressed, the buzzer setting will go to
“buzzer on.”
Select “FIRMWARE UPDATE” from the main
menu.
The firmware file (NVSPRO.BIN) should be
placed in the root directory of a memory card
or the internal hard drive. Select [In HDD]
(hard disk drive) if the firmware file is to be
placed in the root directory of the internal
hard drive.
Select [In Memory Card] if the firmware is in the
root directory of the memory card. If you
selected the memory card, insert the memory
card into the NVS2501.
Caution
● The NVS2501 indicates the completion of the test using the buzzer
sound. The power does not turn off automatically at the completion
of the test.
● The NVS2501 returns to the initial mode only after the user pushes
the control key for more than 2 seconds.
● It is strongly recommended that the AC adapter be connected for
this test in order to prevent battery failure during the process.
0 Bad Clusters Found.
HDD Full Test
149.0 GB
Off
Check it again at PC.
Error found during full test. Further use of
NVS2501 may result in the loss of backup data.
Consult your authorized NEXTODI dealer for
service.