Metalfab Spinloader - Manual (Page 3)

3
The following should be checked at regular intervals:
1. Inspect the gasket attached to the base of the Spin Loader.
Replace with new gasket if torn.
2. The Spin Loader’s top and lower bearings are packed with a
general purpose grease and should not require any additional
lubrication. Both bearings have an expected bearing life of 1 to
2 years under normal use. If a bearing fails, it should be
replaced with a Metalfab spare part or equal.
WHEN INQUIRING ABOUT ANY SPIN LOADER, ALWAYS REFER
TO THE SERIAL NUMBER STAMPED ON THE METALFAB
NAMEPLATE.
METALFAB SERVICE
Metalfab, Inc.
Prices Switch Road
P.O. Box 9
Vernon, NJ 07462
Phone (973) 764-2000
Fax (973) 764-0272
Email: [email protected]