beautypg.com

Bradford White DH-75T-60FB-3X User Manual

Page 13

background image

13


12. Mark the mounting screw hole locations for the backing plate. Rotate

the backing plate in order to gain access to the markings. With a 3/16
(4. 5 mm) inch diameter drill bit (not supplied), drill holes for the
supplied wall anchors. Install the wall anchors and secure the backing
plate to the wall with four (4) #10 x 1 inch screws (supplied) (See Figure
12). Note: Certain construction of walls may require the use of a
different type of anchoring means than supplied.

Figure 12

IMPORTANT

When the installation is complete, visually inspect the air intake
system to insure that all joints are completely sealed.




This manual is related to the following products: