Bradford White DH-75T-60FB-3X User Manual
Page 10
10
Figure 7
8. Extend the six (6) inch (15.2 cm) diameter telescopic tube to its
maximum length. Place the large end of the six (6) inch (15.2 cm)
diameter telescopic tube over the collar on the outer wall mounting plate.
Drill three (3) 1/8 inch (3.2 mm) diameter holes, 120
o
apart, through the
six (6) inch (15.2 cm) diameter telescopic tube into the collar on the
outer wall mounting plate. Fasten with three
(3) #8 sheet metal screws
(supplied). Using the supplied special RTV silicone sealant, apply a
sufficient amount to seal the joint (See Figure 7).
Figure 8
This manual is related to the following products: