Bradford White D-4-504S6FSX - Manual (Page 6)

6
General Information continued-
IMPORTANT
Before proceeding, please inspect the water heater and components for
possible damage. DO NOT install any damaged components. If damage is
evident, please contact the supplier where the water heater was purchased or
the manufacturer listed on the rating plate for replacement parts.
This water heater has been manufactured for operation at altitudes from sea
level to 2000 feet (610 m) (unless otherwise specified on the water heater
rating plate). For use of this water heater at an elevation greater than 2000
feet (610 m), contact the dealer or manufacturer listed on the rating plate for
information on any necessary modifications. Uncorrected operation of this
water heater may create a hazard to life and property.
Make sure that you check the rating plate and combination gas control on the
water heater to be certain that the type of gas being supplied corresponds
with the marking on the rating plate and combination gas control.
A sacrificial anode is used to extend tank life. The removal of this anode, for
any reason, will void the warranty. In areas where water is unusually active,
an odor may occur at the hot water faucet due to a reaction between the
sacrificial anode and the impurities in the water. If this should happen, an
alternative anode may be purchased from the supplier that installed this water
heater. This will minimize the odor while protecting the tank. Additionally, the
water heater should be flushed with appropriate dissolvers to eliminate any
bacteria.