B&C Technologies HI Series Commercial - Manual (Page 30)

Operation
Wash Program Execution
Pressing the START key will start the
machine.
Partial Program
A program can be partially run. After
selecting the program you wish to execute,
the display will show:
Instead of pressing ENTER to execute the
program, press the ADVAN key. The cycles
within the program will be displayed
incrementally. Choose the point at which
you would like to begin, and press the
START key. The machine will begin
operation from this point.
Displaying the Current
Program and Step
While the machine is in operation, pressing
then ENTER key will cause the display to
show the current program number and step.
PRG 1 STP 3
Soak
You can insert a pause at any point of the
wash program with the exception of
distribution and spin. To do so, simply press
the PAUSE key. The display will begin
showing a time, counting up as long as the
machine remains paused. Pressing the
START key will restart the program at the
point it was paused. As long as the
machine is paused, all other WDT (watch
dog timers) are paused as well.
Advance
While any program is running, you can end
the current step and advance to the next
one by pressing the ADVAN key. If the key
is pressed during a spin, the spin will be
aborted, and the standard spin slow down
time will be activated.
Halting a Program
At any time during the execution of the
wash program, the running program can be
terminated by pressing the STOP key.
Water Level Refresh
While a program is running, if the water
level drops to a level which is 3cm below
the target level, cold water will automatically
be added to replenish the level.
Unbalance
If, during a spin segment, the load is
excessively out of balance, the spin will
stop, and a redistribution of the goods will
take place. If three consecutive out of
balances occur, the machine will end the
program. After the first unbalance, the
balance indicator will light on the control
panel.
Power Failure
SINGLE CYCLE
Then, using the INC and DEC keys, you
may choose the cycle you wish to run
(PREWASH, WASH, RINSE, SPIN,
UNROLL). When you have selected you
cycle, confirm by pressing ENTER. The
display changes to:
RUN?
30
PRWH 1 EXECUT.?