Cabletron Systems SEHI100TX- - Manual (Page 65)

Chapter 7: Local Management
7-24 SEHI100TX User’s Guide
7.9.2 Using the ENABLE PORT Command
The ENABLE PORT command lets the user enable the selected port. The
user must first use the PORT command to select the desired port.
Use the following steps to set the PORT ENABLE command:
1. Use the arrow keys to highlight the ENABLE PORT command at the
bottom of the screen.
2. Press ENTER. The corresponding port is enabled and the Port Admin
Status field is updated.
7.9.3 Using the DISABLE PORT Command
The DISABLE PORT command lets the user disable the port selected in
the PORT command. The user must first use the PORT command to select
the desired port.
Use the following steps to set the DISABLE PORT command:
1. Use the arrow keys to highlight the DISABLE PORT command at the
bottom of the screen.
2. Press ENTER. The corresponding port is enabled and the Port Admin
Status field is updated.
7.9.4 Exiting the Device Statistics Screen
Use the following steps to exit the Device Statistics screen and return to
the Feature Selection screen:
1. Use the arrow keys to highlight the RETURN command at the bottom
of the screen.
2. Press ENTER. The Feature Selection screen appears.
SEHI Book Page 24 Wednesday, May 15, 1996 10:42 AM