Dell Latitude Cpi - Manual (Page 2)

• A modular hard-disk drive that can be installed in the
media bay of the Dell Latitude C/Dock Expansion
Station.
The following features are not offered on the Dell Lati­
tude CP and CPi computers:
• The Ml33ST configuration described in Chapter 1,
“Introduction,” and Appendix A, “Technical Specifi­
cations,” of the Reference and Troubleshooting
Guide
• The IntelliSpin feature described in Chapter 2,
“Using the System Setup Program,” oftht Reference
and Troubleshooting Guide
Inserting
Drive a CD Into the CD-ROM
The first time you use the CD-ROM drive, check to see if
there is a white tab on the CD spindle. If there is such a
tab, remove it.
To avoid damaging your CD or the CD-ROM drive, it is
important to seat the CD properly. First, center the CD
on the spindle (see Figure 1-1). Then gently press the
CD down on both sides of the spindle until the CD snaps
into place.
NOTE: The CD-ROM drive can be used only in the mod­
ular bo}’ of the computer or the media bey of the Dell
Latitude C/Dock Expansion Station. Do not tiy to con­
nect the CD-ROM drive to any external connector on the
input/output (I/O) panel of the computer or C/Dock
Expansion Station.
Figure 1-1. Inserting a CD Into the CD-ROM
Drive
Pc Card Information
If the computer uses the Microsoft® Windows® 95 or
Windows 98 operating system, do not put a network PC
Card into the PC Card slot before you turn on your com­
puter for the first time. A network PC Card that is left in
the computer during the operating system setup may
cause installation difficulties. You may insert and use any
PC Card after the operating system setup is complete.
If the computer uses the Microsoft Windows NT® oper­
ating system, do not install any PC Card before you turn
on the computer for the first time. You may insert and use
any PC Card after the operating system setup is complete.
To avoid damaging the PC Card eject button, never leave
it in the “out” position (extended beyond the computer
case). If you accidentally press the PC Card eject button,
remove and reinstall the PC Card immediately to make
sure the button stays flush with the computer case (see
Figure 1-2).
1-2 Dell Latitude CP and CPI Documentation Update