Citizen Systems 500 - Manual (Page 23)

23
English
1. Select the desired item according to the status of the ON LINE (1) and FONT (2) indicators
(on, off, blinking) by referring to the following table or to the printout produced by the printer.
2. Press and release the PITCH button (6) to set the item’s status. The item’s status will
change each time you press the PITCH button. The status of the item is shown by the pitch
indicators (3) will be either on, off or blinking. By referring to the following table or to the printout
produced by the printer the status can be selected.
To change additional settings, repeat steps 1 and 2 above for each item required.
Press LOAD/PARK to exit the Initial Setup mode. The FONT indicator will go off and the current
conditions will print.