Casio IT-600 - Manual (Page 45)

E-43
4. Connect the USB cable (DT-380USB) to the USB client port on the back of the USB
cradle, and then connect it to the PC. The USB host port is used when connecting the
cradle with another USB peripheral device.
USB host device
PC
5. Align the USB cradle mount holes on the back of the Handheld Terminal with the
mount hooks on the cradle after aligning the contacts on the bottom of the
Handheld Terminal with the power contacts of the cradle.
The power indicator LED on the front of the USB cradle will light green if the
Handheld terminal has been properly mounted.
Status of Indicator 1:
Orange: Charging
Red:
Standby due to battery pack error or outside charging temperature range
(charging begins when the temperature is within the charging temperature range)
Green: Charging complete
Important!
• Always make sure to first remove the Handheld Terminal from the USB cradle
when switching the selector switch.
• Never short out the power contacts of the USB cradle. This can damage the
USB cradle.
• Do not subject the Handheld Terminal and USB cradle to vibration or impact
during communication. This can cause communication to be interrupted.
• When mounting the Handheld Terminal, securely attach to the mount hooks of
the USB Cradle and check that the power indicator LED on the front of the
USB Cradle lights green. Charging and communication will not proceed
properly if the Handheld Terminal is not mounted properly.
IT600_E_P40_51.p65 07.3.8, 4:10 PM 43