Dell PowerEdge Rack Enclosure 4820 - Manual (Page 3)

Installation of Equipment Shelf
If the distance between the EIA mounting flanges, front to back, is more than 28.75”
then the Plastic Spacers [G] may be needed between the Shelf [C] and the Rear
Mounting Angle [A]. Install Plastic Spacers (narrow end first) into the rectangular
cutouts in the rear flange of Shelf [Cj. The cutouts are located just inside the rear
alignment tabs. Large end of Spacer to protrude rear of Shelf.
6. Position Shelf [C] with flanges down and tabs extending toward the rear, use radius
tabs on bottom to align Shelf [C] with Rear Mounting Angle [A]. Install alignment tabs
at the back of the Shelf [C] into the rectangular slots on the Rear Mounting Angle [A].
7. Center front panel of Shelf [C] between ’U' height indicator holes [F] of the Front Panel
Mounts [D], Push to engage tabs.
\
' "n ll
RED • 1 I
MARKING J[lj
V
rSlINtjl I
- ' K j .
Information in this document is subject to change without notice.
© 1994-1995 Dell Computer Corporation. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell
Computer Corporation is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and DellWare are registered trade­
marks, Latitude is a trademark, and TechFax is a service mark of Dell Computer
Corporation: MS-DOS. Microsoft and Windows are registered trademarks and
Windows NT and Windows for Workgroups are trademarks of Microsoft Corporation:
Pentium is a registered trademark and lntelDX4 and lntel3S6 are trademarks of Intel
Corporation: CompuServe is a registered trademark of CompuServe. Inc.: PRODIGY
a registered trademark of Prodigy Services Co.: Lotus is a registered trademark of
Lotus Development Corporation, OS/2 is a registered trademark of International
Business Machines Corporation: UNIX \s a registered trademark of UNIX System
Laboratories, Inc., a wholly owned subsidiary of Novell. Inc.: VESA is a registered
trademark of Video Electronics Standards Association.
Other trademarks and trade names may be used in this document to refer to either
the entities claiming the marks and names or their products.
Dell Computer Corporation disclaims any proprietary interest in trademarks and trade
names other than its own.
August 1999 P/N 7163U
8. Push and turn fasteners [E] clockwise 1/4 turn with coin or flat head screwdriver. In
locked position, red markings will not show. P/N 7163U
www.dell.com