En restore the camera to factory default settings – Concord Camera Eye-Q 4062AF User Manual
Page 46

44
En
RESTORE THE CAMERA TO FACTORY DEFAULT SETTINGS
To restore the default settings in your camera:
1. Press when Restore Default is highlighted in the camera.
2. Press or to select No or Yes.
• When No is selected, no change is made. The LCD returns to the previous screen.
• When Yes is selected, the LCD shows “Are you sure?”
3. Press or to select Yes or No.
• If No is selected, no change will be made. The LCD returns Setup page.
• If Yes is selected, the camera will be reset to the factory default setting. The LCD will show “Restoring...”
for a few seconds and then return to setup page. The Default settings will be restored.
Note: Please refer to the table below for the default settings.
OPTION DEFAULT
STATUS
Camera Mode
Single Shot
Image Size
2560 x 1920 (Concord Eye-Q 5062 AF); 2272 x 1704 ( Concord Eye-Q 4062 AF)
Quality Normal
Flash Auto
Flash
White Balance Auto
LCD Brightness
Center (0)
Scene Selection OFF
Exposure Compensation 0
ISO Auto
Metering Matrix
Photo Effect
None
Time Out 2 min
Slide Show Interval
2 Seconds
Beep ON
Quick View
1 Sec
AF Mode
Multi-Area
Continuous Repeat
No
AF Assist Light
Auto
TV Mode
NTSC for USA/Japan, PAL for Europe/Asia
Date/Time Format
USA/Japan: MM/DD/YYYY, 12-hour
Europe/Asia: DD/MM/YYYY, 24-hour
RESTORE THE CAMERA TO FACTORY DEFAULT SETTINGS
DC4062-5062 UG(514173-00)-E 44
5/31/04, 10:14:27 AM