Installing batteries – Motorola DIGITAL CABLE RECEIVER DCT2500 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING THE REMOTE CONTROL
Installing Batteries
Before you can use the remote control, you must install two AA (1.5-volt)
alkaline batteries:
N
Slide open the battery door on the back of the remote control.
2
Insert the batteries in the direction indicated on the inside of the
battery compartment.
Batteries installed incorrectly can cause battery leakage and corrosion that
will damage the remote control.
3
Slide the battery door closed until it snaps into place.
Point the remote control at the DCT2500, press
CABLE
, and then press
POWER
. If the DCT2500 does not turn on, check the orientation of the
batteries or replace with new batteries.
Your remote control may be different from the one illustrated here. Refer to the
remote control instruction guide for details on battery installation.
1 6